Einleitung

Replace your modem to regain dial-up internet access.

  1. Use your thumbs to push the two battery retaining tabs away from the battery.
    • Use your thumbs to push the two battery retaining tabs away from the battery.

    • The battery should pop up enough to rotate it toward yourself and lift it out of the lower case.

    Kommentar hinzufügen

  2. Remove the three 2.3 mm Phillips screws securing the memory cover to the lower case.
    • Remove the three 2.3 mm Phillips screws securing the memory cover to the lower case.

    Kommentar hinzufügen

    • Lift the memory cover slightly and pull it toward yourself to remove it from the lower case.

    Kommentar hinzufügen

    • Remove the following ten screws:

      • Two 14.7 mm shouldered Phillips.

      • Three 12.3 mm Phillips.

      • One 3.8 mm T8 Torx.

      • One 6.8 mm T8 Torx.

      • Three 1.3 mm Phillips.

    Kommentar hinzufügen

    • The ZIF cable is located underneath the bottom RAM slot. If your PowerBook has both RAM slots occupied, make sure to remove the RAM chip.

    • Use your fingernails to separate the ZIF cable lock away from its socket. (Move the two brown bits down 1mm)

    • The ZIF cable lock will move about a millimeter away from the socket before it stops (see picture 2). Do not try to remove the ZIF cable lock.

    The ZIF cable locks are the little grey pieces seen on the cable-side ends of the white bar. They will slide, as per detailed picture, toward the cable.

    web - Antwort

  3. Frohes Fest, frohes Tüfteln!
    Satte 12 € Rabatt auf jeden Einkauf ab 50 €. Einfach den Code FIXMAS12 am Ende deines Bestellvorgangs eingeben
    Frohes Fest, frohes Tüfteln!
    Satte 12 € Rabatt auf jeden Einkauf ab 50 €. Einfach den Code FIXMAS12 am Ende deines Bestellvorgangs eingeben
    • Use the tip of a spudger to slide the trackpad ribbon cable out of its socket.

    Kommentar hinzufügen

    • Remove the four 3.4 mm Phillips screws from the PC card side of the PowerBook.

    • When replacing these screws, you must reinstall each screw in the correct order. Begin by installing the screw closest to the display hinge, and go out from there.

    Kommentar hinzufügen

    • Remove the four 3.4 mm Phillips screws from the DVI connector side of the PowerBook.

    • When replacing these screws, you must reinstall each screw in the correct order. Begin by installing the screw closest to the display hinge, and go out from there.

    • During reassembly, make sure to reinstall the two screws on the right into their appropriate locations, and not the DVI port anchor holes.

    Kommentar hinzufügen

    • Depress the display latch release button and open your display.

    Kommentar hinzufügen

    • Starting near the display, lift the upper case straight up off the lower case, minding any cables that may get caught.

    Sometimes the "tags"/"lugs" that are around the edge of the top & bottom frame, be careful not to bend them as when putting back the covers they will not merge. I used a screwdriver to poke through the hole the screw was supposed go in & push against the "inside nut" to let the tag from the top slide down between the 2 tags. The "inside nut" is like the one right next to the ribbon cable as shown in Dia.14. The screws are from Dia. 7&8.

    harry allcock - Antwort

    in what direction does one move the ZIF cable lock? what/where is its socket?

    Ian - Antwort

    When putting the machine back together (following steps in reverse), make sure the trackpad ribbon cable comes through the underside of the computer — there is an opening that the cable needs to go through and you will want to “thread the needle” with the cable before securing the upper case again.

    Tim - Antwort

    • If necessary, peel back the strip of aluminum tape covering the modem cable.

    Kommentar hinzufügen

    • Use the flat end of a spudger to pry the modem cable connector up off the modem.

    Kommentar hinzufügen

    • Disconnect the RJ-11 cable from the modem.

    Kommentar hinzufügen

    • Use a 4 mm nut driver to remove the two nuts securing the modem to the PC card cage.

    Kommentar hinzufügen

    • Lift the modem straight up off the studs on the PC card cage.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Angehängte Dateien

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 1,829