Zum Hauptinhalt wechseln

Einleitung

This is a prerequisite only.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate. Make sure the screws are kept in a safe place to insure they are not lost. Remove the back plate.
    • Use a Torx T3 screwdriver to unscrew the four 3.5 mm Torx T3 screws holding the back plate.

    • Make sure the screws are kept in a safe place to insure they are not lost.

    • Remove the back plate.

  2. The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner. Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.
    • The plastic frame is clipped inside the steel body with four clips, two each on the left and the right side of the watch, near the corners. You can stick a small screwdriver into the cutouts right above the clips and gently lever the plastic frame up, corner by corner.

    • Once the clips are released, use a pair of tweezers to grab onto the black plastic frame and remove the internal hardware.

    • Adhesive on the back side of the battery holds the internal components to the front case.

    • Use tweezers or a plastic opening tool to disconnect the ribbon cable from the motherboard.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team 1-7, Leahy Fall 2015 Mitglied von USF Tampa, Team 1-7, Leahy Fall 2015

USFT-LEAHY-F15S1G7

3 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 0

Letzten 7 Tage: 0

Letzten 30 Tage: 0

Insgesamt: 62