Einleitung
This guide will walk you through the simple steps to replace the landing gears to help your drone land and fly properly.
Was du brauchst
-
-
Remove the eight 5.2mm screws located on the drone base using a Phillips 00 screwdriver with a thin end.
-
-
-
-
Remove the two 5.2mm screws holding the landing gear in place using a Phillips 00 screwdriver and an extension if needed.
-
-
-
Once the inside screws are removed, carefully pull off the one of the landing gear legs. Repeat this step for the other leg.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
USF Tampa, Team S2-G5, Sullivan Spring 2017 Mitglied von USF Tampa, Team S2-G5, Sullivan Spring 2017
USFT-SULLIVAN-S17S2G5
4 Mitglieder
5 Anleitungen geschrieben
