Einleitung
This guide will walk you through the 16 steps to replace the top shell of the Drone.
Was du brauchst
-
-
Use the heavy duty spudger tool to pry off metal caps by pushing the spudger up into the cap.
-
-
-
Twist the white spindle sleeve counter clockwise to align locking pin inside with the opening.
-
-
-
-
-
Remove Blade Guards by unscrewing two 13 millimeter screws using Philips #0. Pull out the guards. Repeat the steps for the other three corners.
-
-
-
Unscrew two 9 mm screws located inside the legs. Repeat the same procedure for the other three legs
-
-
-
Unplug the camera wire.
-
Press the hold release button and slide out the camera module away from the button.
-
-
-
Remove the motor protection cover by unscrewing two 9 mm screws using Philips #0. When the screws are off, use your fingers to pull the motor protection cover off. Repeat the procedure for the other three arms.
-
-
-
Unclip the motor cable from the shells housing using two pry tools. Repeat the same procedure for the other three arms.
-
-
-
Remove 3 9mm screws around the motor housing. Repeat the steps for the three other arms.
-
-
-
Remove four 9 mm screws located where the legs originally are placed. (Use a thin head screwdriver)
-
-
-
Cut the yellow strips using a scalpel. Pry open the casing using pry tools working gently around the corners.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
UW Tacoma, Team 2-3, Rose Winter 2017 Mitglied von UW Tacoma, Team 2-3, Rose Winter 2017
UWT-ROSE-W17S2G3
4 Mitglieder
5 Anleitungen geschrieben
