Zum Hauptinhalt wechseln

Einleitung

The speed (1-2) Switch is either stuck or won't change speed of rotation.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Remove the backplate. Using a Torx T20 screwdriver, remove the four screws attaching the back plate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

  3. Remove the gear casing from the body. Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.
    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

  4. Locate small metal bar above plastic part of drill.
    • Locate small metal bar above plastic part of drill.

    • Attempt to move bar back and forth. If it wont move, try to move it while rotating the chuck. If it still will not move, there is a problem with the gears. For help see the Planetary Gear Replacement Guide

  5. If the bar moves, next check the small plastic switch that is numbered 1 and 2. Make sure the small tabs on the underside of the switch that move the bar are intact.
    • If the bar moves, next check the small plastic switch that is numbered 1 and 2.

    • Make sure the small tabs on the underside of the switch that move the bar are intact.

    • Replace switch as needed.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

Evan Long

Mitglied seit: 15.04.2010

232 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 15-48, Garner Spring 2010 Mitglied von Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Mitglieder

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 3

Insgesamt: 3,270