Gemeinsam reparieren - Jetzt registrieren

Einleitung

This is a guide on how to take off the Razer Kishi v2 pro Front panel. Use this guide as a prerequisite for all other replacement guides related to this device.

Was du brauchst

Schritt 1 Front Panel

Razer Kishi v2 Pro Front Panel Replacement, Front Panel: Schritt 1, Bild 1 von 1

Put the device down with the bottom facing up.
Remove the eight 12 mm screws from the back of the controller using a T5 screwdriver.

Bearbeiten

Frag FixBot

Schritt 2

Razer Kishi v2 Pro Front Panel Replacement: Schritt 2, Bild 3 von 3

Gently apply light pressure to the front top half of the controller and slowly lift it up.
When you hear a click, the two halves should be successfully disconnected.
When you separate the two parts from each other, two of the back bumpers might fall out. If the bumpers do fall out don't worry because they just snap back in.
Be careful when doing this, if you apply too much pressure you could rip the ribbon cable.
Repeat for the opposite side of the controller.