Einleitung

The whammy bar spring can dislodge from its mounts causing the bar to lose tension. This guide will show you how to replace the whammy bar spring.

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the strap by pulling it off of the mounts located on the body and neck.
  • Remove the strap by pulling it off of the mounts located on the body and neck.

Kommentar hinzufügen

Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a  screwdriver.
  • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

  • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

  • Pull off the rear case.

Kommentar hinzufügen

  • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

  • Pull off the top shell of the neck to expose the internal features.

Kommentar hinzufügen

  • Remove the two 7mm Phillips #2 screws from the black wire retainer.

  • Pull off the black wire retainer.

Kommentar hinzufügen

  • Reach one finger under the guitar to push the whammy bar and its attached components from the case.

Kommentar hinzufügen

  • Remove both of the plastic side tabs by gently pulling them off.

Kommentar hinzufügen

  • Remove the two plastic tabs from the whammy bar casing.

  • Keep the spring connected to the plastic tabs throughout this step.

Kommentar hinzufügen

  • Using two hands, remove the spring from the plastic tabs.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Krista Round

Mitglied seit 18.04.2018

139 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team S17-G1, Livingston Spring 2018 Mitglied von Cal Poly, Team S17-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S17G1

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 4

Letzte 30 Tage: 18

Insgesamt: 121