Zum Hauptinhalt wechseln

Einleitung

The whammy bar spring can dislodge from its mounts causing the bar to lose tension. This guide will show you how to replace the whammy bar spring.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Remove the strap by pulling it off of the mounts located on the body and neck. Remove the strap by pulling it off of the mounts located on the body and neck.
    • Remove the strap by pulling it off of the mounts located on the body and neck.

  2. Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a  screwdriver. Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver. These screws can also be Torx on some models.
    • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

    • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

    • These screws can also be Torx on some models.

    • Pull off the rear case.

  3. Remove the five 12mm Phillips #1 screws along the neck with a  screwdriver. Pull off the top shell of the neck to expose the internal features. Pull off the top shell of the neck to expose the internal features.
    • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

    • Pull off the top shell of the neck to expose the internal features.

  4. Remove the two 7mm Phillips #2 screws from the black wire retainer. Pull off the black wire retainer. Pull off the black wire retainer.
    • Remove the two 7mm Phillips #2 screws from the black wire retainer.

    • Pull off the black wire retainer.

  5. Reach one finger under the guitar to push the whammy bar and its attached components from the case.
    • Reach one finger under the guitar to push the whammy bar and its attached components from the case.

  6. Remove both of the  plastic side tabs by gently pulling them off. Remove both of the  plastic side tabs by gently pulling them off.
    • Remove both of the plastic side tabs by gently pulling them off.

  7. Remove the two plastic tabs from the whammy bar casing.
    • Remove the two plastic tabs from the whammy bar casing.

    • Keep the spring connected to the plastic tabs throughout this step.

  8. Using two hands, remove the spring from the plastic tabs.
    • Using two hands, remove the spring from the plastic tabs.

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

Krista Round

Mitglied seit: 18.04.2018

157 Reputation

1 Anleitung geschrieben

Team

Cal Poly, Team S17-G1, Livingston Spring 2018 Mitglied von Cal Poly, Team S17-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S17G1

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 3

Letzte 30 Tage: 19

Insgesamt: 454