Einleitung

This guide will show how to replace the speaker on the Casio camera

Ersatzteile

Kein Ersatzteil erforderlich.

Remove the four screws on the side with the speaker
  • Remove the four screws on the side with the speaker

Kommentar hinzufügen

Remove the four screws from the bottom of the camera.
  • Remove the four screws from the bottom of the camera.

  • Note: Bottom screws are longer than the top ones, so label accordingly for easy reassembly

Kommentar hinzufügen

Remove the four screws on the side opposite of the speaker.
  • Remove the four screws on the side opposite of the speaker.

Kommentar hinzufügen

Pull apart the bottom casing.
  • Pull apart the bottom casing.

Kommentar hinzufügen

Remove ribbon from the rear casing. Set aside rear casing.
  • Remove ribbon from the rear casing.

  • Set aside rear casing.

Kommentar hinzufügen

Use tweezers or prongs to pry the LCD screen off from the opening. Note: The bottom of the LCD screen is attached to the frame by a few pieces of black tape.
  • Use tweezers or prongs to pry the LCD screen off from the opening.

  • Note: The bottom of the LCD screen is attached to the frame by a few pieces of black tape.

Kommentar hinzufügen

Lift up the LCD screen, slowly move it to the other side. Lift up the LCD screen, slowly move it to the other side.
  • Lift up the LCD screen, slowly move it to the other side.

Kommentar hinzufügen

Pry off the LCD casing which is taped on to the frame. Pry off the LCD casing which is taped on to the frame.
  • Pry off the LCD casing which is taped on to the frame.

Kommentar hinzufügen

Flip open the connector holding the ribbon. Pull out the LCD screen with the ribbon from the camera. Pull out the LCD screen with the ribbon from the camera.
  • Flip open the connector holding the ribbon.

  • Pull out the LCD screen with the ribbon from the camera.

Kommentar hinzufügen

Pull apart the front casing. Pull apart the front casing.
  • Pull apart the front casing.

Kommentar hinzufügen

Remove two screws on the side where the battery is located. Remove the lanyard loop after the screws come off.
  • Remove two screws on the side where the battery is located.

  • Remove the lanyard loop after the screws come off.

  • Slowly pull the side casing so it becomes dislocated from the top of the camera frame.

Kommentar hinzufügen

On the front of the camera near the flash flip the connector holding the ribbon. Remove the ribbon from the connector.
  • On the front of the camera near the flash flip the connector holding the ribbon.

  • Remove the ribbon from the connector.

Kommentar hinzufügen

Carefully remove the L shaped frame from the camera At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab. Pop the frame off the bumps and tabs.
  • Carefully remove the L shaped frame from the camera

  • At the bottom of the camera the L shaped frame is being held in by two plastic bumps and a metal tab.

  • Pop the frame off the bumps and tabs.

  • Note: There is a yellow and orange wire soldered onto the camera. Be careful not to pull them off.

  • The blue box is the speaker

Kommentar hinzufügen

Remove the speaker with tweezers
  • Remove the speaker with tweezers

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Christian

Mitglied seit 28.01.2011

320 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 4-38, Regan Winter 2011 Mitglied von Cal Poly, Team 4-38, Regan Winter 2011

CPSU-REGAN-W11S4G38

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 2,510