Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Remove the eight screws holding the wood-patterned cover to the microwave frame.
-
The first four screws are located on either side of the microwave front.
-
-
-
-
Remove the additional four screws securing the wood-paneled case to the microwave frame.
-
-
-
Placing your hands on either side of the case, slide the case back gently until you feel it completely separate from the microwave frame.
-
Lift the case upward slowly until the case is free of the microwave.
-
-
-
Locate the fan in the newly exposed interior.
-
Try spinning the fan with your finger. If it spins freely, the fan is not jammed.
-
If the fan does not spin freely, locate what is jamming the fan and remove it.
-
-
-
If the fan is not jammed yet still does not work, check that there are no disconnected wires, especially to the fan.
-
In order to work properly, there should be two wires going in and out of the fan. If you are missing either of these wires, locate the loose wire/s and connect them.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 2-12, Propen Fall 2012 Mitglied von Cal Poly, Team 2-12, Propen Fall 2012
CPSU-PROPEN-F12S2G12
3 Mitglieder
6 Anleitungen geschrieben
