Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
-
Drehe alle 18 Kreuzschlitzschrauben auf der Rückseite heraus.
-
Hebe die Rückabdeckung vorsichtig hoch. Du musst vielleicht ein bisschen wackeln, es gibt aber keine weiteren Klammern, so sollte sie sich nach Entfernen der Schrauben leicht lösen.
-
-
-
-
Löse sieben Stecker von der Platine.
-
Entferne sieben Schrauben von der Platine.
-
Hebe das Netzteil aus dem Gerät heraus. Achte dabei darauf, dass sich keine Kabel verfangen.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Inspect all electrolytic capacitors on the power supply board and replace any that are bulging or leaking.
-
On my board there were 2ea 2200uf capacitors that were bulging.
-
Remove the old capacitors ensuring you don't overheat or damage the copper pads/tracks on the circuit board
-
In my case I also replaced the 1000uF capacitor
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
18 weitere Nutzer:innen haben diese Anleitung absolviert.
13 Kommentare
would it be possible to replace the 2200uF capacitors with a larger size? this issue has occurred already on this TV and again on another of the same model. Thanks.
Higher voltage rated and better quality caps are what you need, don't change the value of teh capacitor though.
Richdave -
Hello, I have the blinking red lights when I try to turn on my Samsung lcd tv. I checked the capacitors and they seem to be fine except a smaller 16v 12mm capacitor is slightly bulging(not broken or leaking yet). Would that be enough to cause this? And should I just replace it?
Thank you!