Einleitung
This chip allows the user to input information to the device and to navigate the MP3 player's menus.
Was du brauchst
-
-
Using a spudger, wedge the tip between the front and back case to pry them apart.
-
-
-
The black rubber button pad can be removed by simply picking it up.
-
-
-
Flip the LCD screen off the midsection plate to gain access to the space around the input button chip.
-
-
-
-
Using a spudger, pry off the button input chip from the mid-section of the device. To gain best leverage, start at the bottom right corner and level your way up the side of the chip.
-
-
-
Lift open the LCD screen and button input chip to access the entire midsection plate.
-
-
-
Use a Phillips Head screwdriver to unscrew the three 3/16 inch screws that were underneath the button input chip.
-
-
-
Use a Phillips Head screwdriver to unscrew the three 3/16 inch screws that were underneath the LCD screen.
-
-
-
Locate the soldering joints connecting the button input pad to the motherboard.
-
Hold the wires in place for easier access to the soldering joints.
-
Using a soldering iron, melt the solder connecting the red wire to the motherboard. Do the same action to the black wire.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
USF Tampa, Team 1-1, Remmell Fall 2015 Mitglied von USF Tampa, Team 1-1, Remmell Fall 2015
USFT-REMMELL-F15S1G1
5 Mitglieder
14 Anleitungen geschrieben
