Zum Hauptinhalt wechseln

Werkzeuge

Keine Werkzeuge angegeben.

Ersatzteile

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    The needle is the red plastic piece on the end of the arm. The needle snugly fits over the lower portion of the head, or front end, of the arm. The needle is the red plastic piece on the end of the arm. The needle snugly fits over the lower portion of the head, or front end, of the arm.
    • The needle is the red plastic piece on the end of the arm. The needle snugly fits over the lower portion of the head, or front end, of the arm.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    While securing the end of the arm by holding the head in place, use your fingernail to push down on the front edge of the needle. The needle should hang, as shown.
    • While securing the end of the arm by holding the head in place, use your fingernail to push down on the front edge of the needle.

    • The needle should hang, as shown.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    Once the needle snaps free of the head of the arm, remove the needle by pulling down. Take care to only pull on the red portion. WHEN ATTACHING NEW NEEDLE:  Slide the back (open U shaped side) of the needle on first, then  press to snap the front into place. You should hear a click.
    • Once the needle snaps free of the head of the arm, remove the needle by pulling down. Take care to only pull on the red portion.

    • WHEN ATTACHING NEW NEEDLE: Slide the back (open U shaped side) of the needle on first, then press to snap the front into place. You should hear a click.

Ziellinie

2 weitere Nutzer haben diese Anleitung absolviert.

Roberto Rosila

Mitglied seit: 26.01.2014

316 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 1-38, Maness Winter 2014 Mitglied von Cal Poly, Team 1-38, Maness Winter 2014

CPSU-MANESS-W14S1G38

4 Mitglieder

5 Anleitungen geschrieben

Ein Kommentar

On the Crosley CR7002A I am having a problem with the turntable. When the tone arm is moved over any part of the record is slides back to the home position (rest). Is their any adjustment I can make to fix this? Thanks.

thmccullough - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 2

Letzten 7 Tage: 13

Letzten 30 Tage: 45

Insgesamt: 3,521