Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will help you replace the buttons in your Sega Genesis Flashback controller. You’ll need a Phillips #000 screwdriver to complete this guide.
Was du brauchst
-
-
Hold the controller with the bottom plate facing up, and gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.
-
Remove the screws on the back of the controller with the Phillips #000 screwdriver.
-
-
-
Use two fingers to remove each rubber membrane that rests on top of the buttons.
-
-
-
-
Pop the button out from the front side of the controller.
-
Pull the button out from the backside using the other hand.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.