Einleitung

The back speaker emits noise for your phone's ringtones, music, sound effects, and speakerphone conversations. Installing a new back speaker may alleviate distorted or missing noise.

Ersatzteile

Kein Ersatzteil erforderlich.

To remove the back casing, firmly press down and push towards the bottom of the phone.
  • To remove the back casing, firmly press down and push towards the bottom of the phone.

Kommentar hinzufügen

With the casing removed, lift the battery from the indicated indentation.
  • With the casing removed, lift the battery from the indicated indentation.

Kommentar hinzufügen

  • From here, you can now access the SIM card and model/serial numbers.

Kommentar hinzufügen

  • Using the Phillips #00 screwdriver, remove the four indicated screws (4.5 mm).

Kommentar hinzufügen

  • Press the pointed edge of the spudger into the side of the two rubber plugs in order to lift and remove them from the top of the phone.

  • Then, using the Phillips #00 screwdriver, remove the two indicated Phillip screws (6.5 mm).

Kommentar hinzufügen

  • To remove the SIM card, start by pressing the top of the card and push down and away towards the bottom of the phone. Then, as indicated, pull the SIM card out.

Kommentar hinzufügen

  • Begin to slowly lift the back casing of the phone. You should hear a snap when the casing is released.

  • The power, volume, and camera buttons may fall out when separating the front and back casing.

Kommentar hinzufügen

  • Your casing should be separated and the three loose buttons put to the side.

  • Be aware of the wiring on the top of the phone. Make sure not to pull it apart when separating the case.

Kommentar hinzufügen

  • Slowly remove the back casing by gently pulling the ribbon connection.

Kommentar hinzufügen

  • Gently pull on the wires to remove the front casing.

Kommentar hinzufügen

  • Your front casing and front speaker are now released.

Kommentar hinzufügen

  • Locate the back speaker.

Kommentar hinzufügen

  • Use the flat edge of the spudger to gently pry and remove the speaker.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Breanne

Mitglied seit 12.04.2012

187 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 6-24, Amido Spring 2012 Mitglied von Cal Poly, Team 6-24, Amido Spring 2012

CPSU-AMIDO-S12S6G24

3 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 770