Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
To begin, turn the device over so that the bottom is facing up. There are 9 black clips that attach the plastic body to the case. Remove these clips from the case.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a Phillips #2 screwdriver to remove the screw that attaches the top cover to the rear of the device. This will allow you to remove the cover.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Please locate your disc drive
-
Your disc drive should look like the one pictured. If your disc drive does not look as follows please confirm that you are looking at the right guide.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Once you have located your disc drive it is time to remove the drive
-
You will see four silver 1.1mm Phillips #2 screws located on each corner of the disc drive.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Once you have removed the four screws using a Phillips #2 screwdriver you are now able to take out the disc drive
-
Carefully remove the disc drive being sure not to disrupt anything else in the Blu-Ray player.
-
This is how your disc drive should look if you have removed it from the player correctly.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unhook the wire from the drive lens by flipping the black piece up and pulling the wire out, at the area marked.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unhook the left bar in the area circled by pushing the bar to the left, lifting up and then pushing to the right.
-
Make sure the drive lens is pushed back toward the black wheel, as indicated with the big red square.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Slide the Drive Lens up the little metal pole until it is released.
-
This is how the drive lens should look once it is removed.
-