Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using a #1 Phillips head screwdriver, remove the three 10mm screws on the back panel.
-
Tilt the back of the top cover forward to remove from chassis.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently pull up on the ribbon cable by the blue tab to remove it from the power supply board.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect the WiFi board cable connector from the main logic board
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using a #1 Phillips head screwdriver, remove the 7.5 mm screw.
-
Slightly tilt the WiFi module sideways to remove from chassis.
-