Einleitung
This guide shows how to replace the camera.
Was du brauchst
-
-
Insert a fingernail or plastic opening tool in the gap between the rear case and the base of the phone.
-
-
-
Slide your fingernail or plastic opening tool along the edge of the rear case.
-
Lift the case gently from the base.
-
-
-
Insert a fingernail or plastic opening tool into the small gap between the battery and the phone base.
-
Lift the battery out of its recess.
-
-
-
Place your fingernail in the groove of the stylus pen.
-
Pull the stylus pen away from the phone.
-
-
-
-
Remove the twelve 4mm Phillips #00 screws from the back chassis.
-
-
-
Insert the plastic opening tool into the Stylus Pen placement holder.
-
Lift the plastic opening tool so that the midframe separates from the base.
-
-
-
Remove the single screw beside headphone jack.
You can skip this step, it is usseles as this screw doesn’t attach the mother board at all
-
-
-
Use tweezers to remove both antenna clips.
-
Use a spudger to disconnect six cable connectors.
-
-
-
Pull up on the motherboard with tweezers.
My mother board is not working what should I do I can't use Bluetooth, WiFi,hotspot or insert sim
My wifi hotspot is not working
-
-
-
Unclip the camera connecting cable using the plastic opening tool from the motherboard
-
Remove loose camera from base
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
37 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
USF Tampa, Team 2-2, Blackwell Fall 2014 Mitglied von USF Tampa, Team 2-2, Blackwell Fall 2014
USFT-BLACKWELL-F14S2G2
4 Mitglieder
25 Anleitungen geschrieben
3 Kommentare
Hi
Thanks for the nice instructions
Do you know if I can use a Note 4 camera (or any better!) for my Note 3?
Are they different in connections?
Thanks
I shall be very thankfull for this act of kindness
