Einleitung

The Vibration motor causes the phone to vibrate and provides the user with haptic feedback during phone use.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Power down your device and make sure that it is turned off.
    • Power down your device and make sure that it is turned off.

    • Place the phone with the screen facing down on a clean flat surface.

    Kommentar hinzufügen

  2. Use your Supdger to remove the back cover of the phone using notch located in the top left corner of the phone.
    • Use your Supdger to remove the back cover of the phone using notch located in the top left corner of the phone.

    • Remove battery by using your Supdger on the notch located directly underneath battery location.

    • During the creation of this guide, we did not have access to a battery in our device.

    Kommentar hinzufügen

    • Remove the SIM Card from the SIM Card holder by gently sliding the SIM Card horizontally.

    • Remove the stylus from the stylus holder.

    Kommentar hinzufügen

    • Using a Phillips #000 Screwdriver, remove the fifteen 4mm screws that secure the rear chassis.

    • Insert your spudger into the stylus socket and pry the midframe from the phone.

    • Move the spudger around edge of phone, carefully prying the midframe from the phone until midframe is entirely separated.

    Kommentar hinzufügen

    • With the pointed end of your spudger, disconnect the two wires (pink and white) located near the bottom of the phone.

    • Using pointed end of your dpudger, disconnect the finger print scanner cable- it is located directly above the pink and white cables.

    Kommentar hinzufügen

    • Using your Spudger's pointed end, pry off the following leads that connect these parts to the logic board in the top left hand corner:

      • Front Facing Camera

      • AMOLED Display Screen

      • AMOLED Capacitive Screen

    Kommentar hinzufügen

    • At the top end, gently insert pointed end of spudger underneath the motherboard.

    • Lift the motherboard up gently. Disconnect the cable connecting the daughter board. It is attached to the underside of the motherboard.

    • Remove the motherboard from the device.

    Kommentar hinzufügen

    • Insert the sharp end of the spudger underneath the golden cables connecting the vibration motor. Gently pry upwards to disconnect them.

    Kommentar hinzufügen

    • Insert one end of the Tweezers into said notch. Pry upwards and grab the round piece to remove the vibration motor.

      • Adhesive holds the motor in place, so force is required to break this bond.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Duc Huynh

Mitglied seit 19.04.2018

177 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team S22-G6, Maness Spring 2018 Mitglied von Cal Poly, Team S22-G6, Maness Spring 2018

CPSU-MANESS-S18S22G6

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 4

Insgesamt: 57