Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Insert a SIM Ejector Tool into the small hole on the left side of the top edge of the device.
-
Press down until the SIM Card Tray begins to protrude out of the device.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the SIM Card Tray from the slot.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Heat the back of the device with a heat gun for 2 minutes
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Once the device is heated, place a suction cup near the bottom of the back of the device Make sure it is placed on the flat part of the glass
-
Gently pull upwards on the suction cup to separate the rear glass from the body of the phone.
-
While pulling upwards, insert a pick under the rear glass
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Keeping the pick under the rear glass, move the pick along the bottom edge of the device to cut the adhesive.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Repeat the previous heating and cutting procedure for the remaining three sides of the phone.
-
Leave a pick on each side as you continue to the next to prevent the adhesive from resealing.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Once all adhesive has been cut, gently lift up the rear glass to remove it.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the S-Pen from the bottom of the device
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove 20 5mm screws with a Phillips #1 Screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Grip the back of the device and press down on the white square to remove the middle housing.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Loosen the power button flex adhesive by holding it with the tweezers.
-
With the tweezers, pry up and remove the power button flex
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Push out the power button with the tip of the tweezers.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.