Einleitung
Use this guide to replace the plastic midframe.
Was du brauchst
-
-
Insert a plastic opening tool or fingernail into the notch in the gap between the rear case and the rest of the phone, located at the top of the device.
-
Gently twist the opening tool to disconnect the clips securing the top of the rear case.
-
-
-
Slide the plastic opening tool left along the top edge and repeat the twisting motion to widen the gap between the rear case and the phone.
-
-
-
Continue to move the plastic opening tool around the perimeter of the top left corner, gently prying up along the rear case.
-
-
-
Pry along the top right side, and continue prying down the right side of the rear case.
-
-
-
-
Wedge a plastic opening tool into the small notch above the battery.
-
Pry the battery up out of its recess.
-
-
-
Using your fingernail, push the SIM card slightly deeper into its slot, until you hear a click.
-
After the click, release the card and it will pop out of its slot.
-
-
-
Use your thumb to slide enough of the SIM card out of its slot to grab ahold of it.
-
Grasp and remove the SIM card away from the phone.
-
-
-
Using your fingernail, push the microSD card slightly deeper into its slot, until you hear a click.
-
After the click, release the card and it will pop out of its slot.
-
-
-
Use your thumb to slide the microSD card out of the slot.
-
Remove the microSD card from the phone.
-
-
-
Remove the ten 4.0 mm Phillips screws securing the midframe to the front panel assembly.
-
-
-
Grasp the left side of the plastic midframe with your thumb and forefinger and lift it away from the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
38 weitere Nutzer:innen haben diese Anleitung absolviert.
