Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the small slit on the bottom edge of the device between the back and front cases.
-
Pop the back case off by inserting your finger and pulling the case away from the phone.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the battery by pushing the bottom edge of the battery up and away from the phone
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove SIM card by pushing down and away from the slot, then pulling it out toward the bottom edge of the phone.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the seven 4.5 mm Phillips #00 screws along the perimeter of the phone.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Staring near the power button, use a plastic opening tool to disengage the plastic clips securing the midframe.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Slide the SD card out of its slot.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Tweezers$4.99-
Disconnect the antenna using Tweezers. Do the lower end first, and then the upper.
-
Do the lower end first, and then the upper.
-
Pull the antenna cable out.
-