Einleitung
Prereq to remove the interior midframe and motherboard assembly.
Was du brauchst
-
-
Remove the ten 3.4 mm Phillips #000 screws from the display side of the midframe.
-
-
-
Two 4.4 mm Phillips #000 screws near the USB port on the battery side of the phone
-
One 4.4 mm Phillips #000 screw
-
-
-
Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips.
-
-
-
-
Gently pull the long sides of the silver bezel out away from the phone to separate the two halves of the midframe.
-
-
-
Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves.
-
-
-
Use a plastic opening tool to pry any remaining corners out of the silver bezel.
-
-
-
Carefully remove the interior midframe/motherboard assembly from the white inner midframe.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
