Einleitung
Prereq to remove the motherboard from the interior midframe.
Was du brauchst
-
-
Carefully wedge the tip of a spudger underneath the antenna cable connector.
-
Delicately lift the spudger directly upwards to disconnect the antenna connector off its socket on the motherboard.
-
-
-
Remove the single 3.0 mm Phillips #000 screw securing the motherboard to the midframe.
-
-
-
-
Pull, but do not remove, the camera end of the motherboard up from the midframe to allow access to the connectors on the rear.
-
-
-
Use the flat end of a spudger to pry the daughterboard connector straight up off its socket on the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.