Zum Hauptinhalt wechseln

Samsung Galaxy Tab 3 8.0 Rear Camera Replacement

Was du brauchst

  1. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Battery - Open up the tablet: Schritt 1, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Battery - Open up the tablet: Schritt 1, Bild 2 von 2
    • Start out by separating the screen from the back cover using the larger plastic opening tool to pry them apart.

    • Be careful when removing the screen as negligence can cause damage.

    Separating the back cover was the hardest part of the procedure for me (a retired electrical/software engineer). I used a large flat screwdriver blade instead of the hard plastic tool shown. Go slow all the way around the tablet and expect pops as the pieces separate. I was not able to re-connect the back cover completely, accepting a paper-thin gap about 30% around the cover, but it is secure.

    Rick Nungester - Antwort

  2. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Remove Back Cover: Schritt 2, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Remove Back Cover: Schritt 2, Bild 2 von 2
    • Once every part of the screen is separated from the back cover, you should be able to fully remove it with your hands.

    Peter how do I know which charging port I need thank you I don't know how else to reach you Tom Patrick mlc@earthlink.net all small case and no spaces thank you

    Tom Patrick - Antwort

    Yikes. I began carefully prizing off the screen - but when it finally came away the connector (near the top of the screen, about 1” from the right side) got ripped, so the unit is damaged beyond repair. I think it would have been helpful if your guide had warned us about this possibility and given some advice about how to make sure it doesn’t happen. I now have a broken tablet and a brand new battery, likewise of no use to me. Pretty heartbroken - the unit had been working fine, mainstay of daily use.

    goodone - Antwort

    For any future people repairing their tablets. DO NOT REMOVE THE SCREEN. I thought my tablet was a Tab 2, but no it was a Tab 3. No heat guns needed. I ended up cracking my screen a bit. I don’t know the extent of the damage yet, but Im probably going to get a replacement screen. You need to pop out the whole thing. Not just the front screen. The reason being that there’s a sort of metal scaffolding holding the screen and the back together. This needs to be separated to put in the new charging port.

    Matt -

  3. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect Battery: Schritt 3, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect Battery: Schritt 3, Bild 2 von 2
    • To remove the battery you must use something small, such as tweezers, to disconnect the battery from its port.

    • Note: the connection lifts up to remove.

  4. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Remove Battery: Schritt 4, Bild 1 von 1
    • After the battery is disconnected, use the pulling tab to safely remove the battery.

    You don't have to, just be careful with battery connector.

    Kyoko Hori - Antwort

    You have to be very careful with the battery connector. On mine, the plug was difficult to remove from the base and I ended up breaking the connections between the base and the circuit board. Maybe use the pry tool to hold the base down while easing out the plug.

    Hugh Morrison - Antwort

    I just did the same thing Hugh...does that mean my tablet is trashed? Can it be repaired?

    tlibert -

    There’s also a pull tab on with label printed on the batery to make the pulling easier.

    IMI Comp - Antwort

  5. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect Speakers: Schritt 5, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect Speakers: Schritt 5, Bild 2 von 2
    • Disconnect the relays attached to the motherboard.

  6. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Speakers: Schritt 6, Bild 1 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Speakers: Schritt 6, Bild 2 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Speakers: Schritt 6, Bild 3 von 3
    • Unscrew the 2.9mm screws from the speakers using a Phillips head #000 screwdriver, then lift the speakers from the device.

  7. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect All Relays: Schritt 7, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect All Relays: Schritt 7, Bild 2 von 2
    • Using the plastic remover tool carefully unseat the four rectangular electric leads from the board. Each rectangle is a different size, the first one is large, the second one is medium, and the last two are small.

    • Using the plastic remover tool carefully unseat the square electric lead (marked in orange) from the board.

    • Using the plastic remover tool carefully unseat the small square and the two rectangular electric leads (marked in yellow) from the board.

  8. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Motherboard: Schritt 8, Bild 1 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Motherboard: Schritt 8, Bild 2 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Unscrew Motherboard: Schritt 8, Bild 3 von 3
    • Unscrew the one 2.9mm Phillips #000 screw above the battery, and the three 2.9mm Phillips #000 screws to the right of the battery.

  9. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Remove the Motherboard: Schritt 9, Bild 1 von 2 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Remove the Motherboard: Schritt 9, Bild 2 von 2
    • Carefully lift the board from the device.

    remove camera mentioned in step 7 before doing this

    as well as disconnecting the 3 connectors at the bottom n vm

    also note that the top left black square comes out with the motherboard

    Kerri - Antwort

  10. Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect the Rear Camera: Schritt 10, Bild 1 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect the Rear Camera: Schritt 10, Bild 2 von 3 Samsung Galaxy Tab 3 8.0 Rear Camera Replacement, Disconnect the Rear Camera: Schritt 10, Bild 3 von 3
    • Flip the motherboard to reveal the rear camera connection and with tweezers gently lift the connector pins and remove the camera.

Abschluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Nutzer:innen haben diese Anleitung absolviert.

Team

USF Tampa, Team 4-2, Brown Fall 2014 Mitglied von USF Tampa, Team 4-2, Brown Fall 2014

USFT-BROWN-F14S4G2

3 Mitglieder

26 Anleitungen geschrieben

Ein Kommentar

That worked a treat, thanks a lot Anthony, I don’t quite know when I broke my rear camera but I suspect it’s after being dropped, unfortunatly more than once, a replacement camera was sourced from ebay and only cost £3.29 that included the postage! So all is well again now.

Here’s a link to where I bought mine, I can recommend them 100%

https://www.ebay.co.uk/itm/Genuine-Rear-...

Once again, Cheers!

mooog1 - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 1,313