Einleitung
Getting to the battery requires disassembling the entire device, but the battery itself is easy to remove.
Was du brauchst
-
-
Place your thumbs on the ends of the screen.
-
Push the watch outward while pulling the band away from the watch.
-
-
-
Use a hair dryer, heat gun, or an iOpener to heat the Gear Fit for 1-2 minutes until it is hot to the touch.
-
-
-
Using tweezers as a lever, pry the inner assembly out of the external casing.
-
This will be harder than removing the screen. Moderate force may be required.
-
-
-
-
Disconnect the ribbon cables connecting the screen to the motherboard by lifting their metal connectors up off of the board with tweezers.
-
-
-
Gently peel the screen assembly up and away from the device using tweezers.
gear fit 2 screen assembly is very expensive at the moment at 135 USD + 10USD shipping… looks like you are buying a whole new unit, ridiculous… i am planning to buy a new GF2 and have my defective GF2 to be source of spare parts in the future ( battery, hear rate sensor, circuit board, etc..) or maybe wait some time till prices go down.
-
-
-
Three ribbon cables hold the motherboard to the rest of the assembly.
-
The battery cable in the front.
-
And two on the side.
-
Using a pair of tweezers, carefully pull each connector away to disconnect it from the rest of the assembly.
-
-
-
The motherboard is a segmented three piece construction.
-
Use tweezers to first lift up, with a moderate amount of force, and free each ends of the motherboard from the assembly.
-
-
-
The motherboard should now be removable from the assembly.
-
Use tweezers to lightly pry, lift, and remove the board by its middle section.
-
-
-
With the motherboard removed, the battery is exposed.
-
A small metal strut protects the battery.
-
Remove the small metal strut by prying it out of both sides of the enclosure.
I look at not working changer but battery broken see here new watch samsung galaxy fit e.
I can tell help you
-
-
-
Remove the battery by pulling on the pull tab.
-
Don't be afraid to use force, the battery is tightly packed into the plastic enclosure.
-
To reassemble your device, follow these instructions in reverse order. Make sure that the ribbon cable connecting the battery is firmly attached; Don't be afraid to use some force.
To reassemble your device, follow these instructions in reverse order. Make sure that the ribbon cable connecting the battery is firmly attached; Don't be afraid to use some force.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
37 weitere Nutzer:innen haben diese Anleitung absolviert.
9 Kommentare
Bgdhdhdhxhzjxjchf
Gdkysgkdgkdgxgmzg
Anyone know where I can find replacement parts for the charging terminals? One of the 5 fell out and I can't seem to find this simple piece anywhere.
Where i can purchase a replacement battery in india?
How much would this repair cost at a fixit store?