Einleitung

The vibrator motor is what allows your watch to vibrate to indicate incoming calls, texts, etc. An offset weight on the shaft of the motor causes it (and in turn, the watch) to vibrate when the motor spins. If your watch is set to vibrate and the vibration feature fails to function, you may need to replace the motor.

Lay the watch face-down on a flat, stable surface.
  • Lay the watch face-down on a flat, stable surface.

Be sure to proofread carefully.

Dan Brown - Antwort

Press the watchband down against the work surface.
  • Press the watchband down against the work surface.

  • Press the tip of a flathead screwdriver against the edge of the spring-loaded holding pin.

Kommentar hinzufügen

With the spring-loaded pin pressed in, the watch band should release easily.
  • With the spring-loaded pin pressed in, the watch band should release easily.

  • Gently pull the band away from the body of the watch.

  • Repeat steps 2 and 3 for the opposite side.

Kommentar hinzufügen

With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners.
  • With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners.

Kommentar hinzufügen

Using a Torx-T5 screwdriver, remove each of the four 4mm screws and set them aside.
  • Using a Torx-T5 screwdriver, remove each of the four 4mm screws and set them aside.

Kommentar hinzufügen

Gently work the plastic opening tool under the top edge of the watch’s back cover.
  • Gently work the plastic opening tool under the top edge of the watch’s back cover.

Kommentar hinzufügen

With the watch’s back cover pried loose, gently lift it away from the front half of the watch. With the watch’s back cover pried loose, gently lift it away from the front half of the watch.
  • With the watch’s back cover pried loose, gently lift it away from the front half of the watch.

Good action shots here!

Dan Brown - Antwort

Lay both halves of the watch body assembly face down (with internal components facing up).
  • Lay both halves of the watch body assembly face down (with internal components facing up).

Kommentar hinzufügen

Locate the vibrator motor on the front half of the disassembled watch. It is located in the corner, at the end opposite the green circuit board.
  • Locate the vibrator motor on the front half of the disassembled watch. It is located in the corner, at the end opposite the green circuit board.

Kommentar hinzufügen

Using the plastic opening tool, gently pry up the motor.
  • Using the plastic opening tool, gently pry up the motor.

Kommentar hinzufügen

Using the plastic prying tool, gently pry away the motor’s contacts and ribbon cable from the watch assembly
  • Using the plastic prying tool, gently pry away the motor’s contacts and ribbon cable from the watch assembly

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

2 weitere Nutzer haben diese Anleitung absolviert.

Keith Cooper

Mitglied seit 25.09.2014

1.171 Reputation

6 Anleitungen geschrieben

Team

USF Tampa, Team 1-7, Brown Fall 2014 Mitglied von USF Tampa, Team 1-7, Brown Fall 2014

USFT-BROWN-F14S1G7

3 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 6

Insgesamt: 608