Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Push the switch on the right-hand side of the device to separate the cover from the main body.
-
Pull the cover away from the main device.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four corner screw covers with a metal spudger.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a metal spudger to remove the screw cover centered at the top.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the six 5mm Phillips #000 screws to detach the front phone mount.
-
Lift the front phone mount up and to the left.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the four 5mm Phillips #000 screws that secure the plate on the left side of the headset.
-
Pull the plate away from the motherboard gently.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use the iFixit opening tool to remove the pop connector holding the wire harness to the motherboard.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the rest of the pop connectors on the motherboard using the iFixit opening tool.
-
Pry at the top of the motherboard with the iFixit opening tool to remove the motherboard.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the eight 5mm Phillips #000 screws on the inner mask.
-
Gently separate the inner mask from the headset by pulling the mask from the inner sides of the lens sockets.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.