Einleitung

This guide will provide a step by step procedure for installing the internal antenna.

Ersatzteile

Kein Ersatzteil erforderlich.

Using your thumb, press down and slide the back cover away from the  camera.
  • Using your thumb, press down and slide the back cover away from the camera.

Kommentar hinzufügen

Remove the battery from the phone.
  • Remove the battery from the phone.

Kommentar hinzufügen

  • Using a Phillips #00 screwdriver, remove the six 4mm screws holding the back case together.

Kommentar hinzufügen

  • Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap.

  • Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.

  • Using your fingers, take the case off.

Kommentar hinzufügen

  • The antenna is located on the bottom of the phone. It is the small rectangular shaped object sticking out on one of the ends.

  • Use a plastic opening tool to prop the antenna out. To do so, slip the tip of the tool on one of the edges of the antenna. Use moderate pressure to pry the antenna out.

Kommentar hinzufügen

  • Using a plastic opening tool, disconnect the connector leading from the antenna to the phone.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Cameron Law

Mitglied seit 12.10.2011

142 Reputation

5 Anleitungen geschrieben

Team

Cal Poly, Team 3-12, Regan Fall 2011 Mitglied von Cal Poly, Team 3-12, Regan Fall 2011

CPSU-REGAN-F11S3G12

4 Mitglieder

14 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 982