Einleitung

The screen casing may become worn or broken over time. This guide will allow you to remove/replace it.

Ersatzteile

Kein Ersatzteil erforderlich.

Slide the latch on the back of the phone up.
  • Slide the latch on the back of the phone up.

Kommentar hinzufügen

Remove the battery.
  • Remove the battery.

Kommentar hinzufügen

After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.
  • After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.

Kommentar hinzufügen

Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.
  • Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.

Kommentar hinzufügen

With a #0 Phillips screwdriver remove the screw which you just uncovered.
  • With a #0 Phillips screwdriver remove the screw which you just uncovered.

Kommentar hinzufügen

Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open. Then disconnect the small power connector near the top of the phone.
  • Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.

  • Then disconnect the small power connector near the top of the phone.

Kommentar hinzufügen

Gently pry up the ribbon-type connector with the spudger.
  • Gently pry up the ribbon-type connector with the spudger.

Kommentar hinzufügen

Carefully pry the logic board from the case with the spudger.
  • Carefully pry the logic board from the case with the spudger.

Kommentar hinzufügen

Once the logic board has been removed, peel the keypad up.
  • Once the logic board has been removed, peel the keypad up.

Kommentar hinzufügen

When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing. When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.
  • When using a spudger the keypad housing comes off quite easily, although it may be necessary to guide the ribbon cable through the slot in the housing.

Kommentar hinzufügen

Remove screws with #0 Phillips screwdriver.
  • Remove screws with #0 Phillips screwdriver.

Kommentar hinzufügen

Carefully pry apart the casing with the spudger tool.
  • Carefully pry apart the casing with the spudger tool.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Nathan Brink

Mitglied seit 11.04.2010

1 Reputation

14 Anleitungen geschrieben

Team

Cal Poly, Team 34-59, Forte Spring 2010 Mitglied von Cal Poly, Team 34-59, Forte Spring 2010

CPSU-FORTE-S10S34G59

4 Mitglieder

14 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,814