Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Lay vacuum on side.
-
Using a Phillips screwdriver, unscrew the screw behind the front wheels, on the edge of the underside of the vacuum cleaner.
-
-
-
Stand the vacuum upright and identify the dial on the front of the vacuum.
-
Unscrew the screw using a Torx 20 screwdriver
-
Pull the dial out.
-
-
-
-
Identify the two gray metal plates at the front of the vacuum.
-
Using the T20 Torx screwdriver, remove the four screws on the smaller gray plate holding the larger gray metal plates.
-
-
-
Remove the small metal plate with the black bolt in the center.
-
Repeat on opposite side near the other wheel
-
-
-
Remove the front wheels by lifting the silver bar that attaches the two wheels.
-
Detach the spring attaching the wheels to the vacuum.
-
-
-
Remove a wheel from the wheel's axel by pulling off the wheel.
-
Slide spring off.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.