Einleitung

Inexpensive acquired camera that has a broken LCD. This is a relative easy and straight forward task.

Here is a recently acquired camera. Initial cost $3.00 Only trouble is, obviously broken LCD Remove the carrying strip. Use a needle and some tweezers to loosen the slip knot.
  • Here is a recently acquired camera. Initial cost $3.00

  • Only trouble is, obviously broken LCD

  • Remove the carrying strip. Use a needle and some tweezers to loosen the slip knot.

Kommentar hinzufügen

Remove one screw on the right of the camera Remove one screw on the left side of the camera Remove the two screws on the bottom
  • Remove one screw on the right of the camera

  • Remove one screw on the left side of the camera

  • Remove the two screws on the bottom

Kommentar hinzufügen

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Split the camera from the battery compartment down. You can use an opening tools, or just your fingernails, if so equipped. This will remove the front part of the case. Remove this screw on the right side of the camera. Keep it separate from the 4 screws previously removed. The are of different length
  • Split the camera from the battery compartment down. You can use an opening tools, or just your fingernails, if so equipped.

  • This will remove the front part of the case.

  • Remove this screw on the right side of the camera. Keep it separate from the 4 screws previously removed. The are of different length

Kommentar hinzufügen

Remove the screw on the bottom of the battery compartment. Keep this screw with the one removed on the previous step. These two screws have a different length than all the other screws. They are the shortest ones in the camera With those two screws removed, you can not separate the back part of the case. Flip the LCD to the right and out of the frame. Do NOT try to remove it yet.
  • Remove the screw on the bottom of the battery compartment. Keep this screw with the one removed on the previous step. These two screws have a different length than all the other screws. They are the shortest ones in the camera

  • With those two screws removed, you can not separate the back part of the case.

  • Flip the LCD to the right and out of the frame. Do NOT try to remove it yet.

  • Remove the screw screws that hold the LCD frame to the logic board. Keep the 3 screws separated from the rest of the screws, due to different length.

Kommentar hinzufügen

With the frame removed, the connector and LCD cable are now fully accessible. Note the to tabs on the cable and their position on the logic board. Flip the tab on the connector carefully up and remove the LCD. Hopefully this is what you will get after replacing the LCD and reassembling the camera in reverse order. Total replacement cost was $15 and 30 minutes of my time.
  • With the frame removed, the connector and LCD cable are now fully accessible. Note the to tabs on the cable and their position on the logic board.

  • Flip the tab on the connector carefully up and remove the LCD.

  • Hopefully this is what you will get after replacing the LCD and reassembling the camera in reverse order. Total replacement cost was $15 and 30 minutes of my time.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

oldturkey03

Mitglied seit 29.09.2010

509.495 Reputation

118 Anleitungen geschrieben

Team

OTS Mitglied von OTS

Business

1 Mitglied

118 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 1,521