Zum Hauptinhalt wechseln

Sew a Ladder Stitch

Was du brauchst

  1. Sew a Ladder Stitch, Sew a Ladder Stitch: Schritt 1, Bild 1 von 3 Sew a Ladder Stitch, Sew a Ladder Stitch: Schritt 1, Bild 2 von 3 Sew a Ladder Stitch, Sew a Ladder Stitch: Schritt 1, Bild 3 von 3
    • Thread your needle and tie a knot in the end.

    • We're using contrasting thread for visibility, but when it comes time for your repair, you'll want to use matching thread.

    • Drive the needle from the back of the material, just before where the tear starts.

    • Pull the thread taut.

  2. Sew a Ladder Stitch: Schritt 2, Bild 1 von 2 Sew a Ladder Stitch: Schritt 2, Bild 2 von 2
    • Take a small stitch, going in and out of the material, on one side of the tear only.

    • Pull the thread taut.

  3. Sew a Ladder Stitch: Schritt 3, Bild 1 von 2 Sew a Ladder Stitch: Schritt 3, Bild 2 von 2
    • Take a small stitch, going in and out of the material, on the other side of the tear, directly opposite of the stitch you just took.

    • Pull the thread taut. This should cinch the material together.

    • If your material bunches, try taking smaller stitches, while ensuring that you line up the stitches on either side of the material.

  4. Sew a Ladder Stitch: Schritt 4, Bild 1 von 2 Sew a Ladder Stitch: Schritt 4, Bild 2 von 2
    • Continue stitching, switching from side to side as described in step 2 and 3 of this guide, pulling the thread taut after each stitch.

    • Stitch until you come to the end of the tear.

  5. Sew a Ladder Stitch: Schritt 5, Bild 1 von 3 Sew a Ladder Stitch: Schritt 5, Bild 2 von 3 Sew a Ladder Stitch: Schritt 5, Bild 3 von 3
    • One the last stitch, drive the needle through both sides of the fabric, taking as small of a stitch as possible.

    • Slowly pull the thread. As you pull, a loop will form. Draw the needle through this loop, and pull the thread taut.

    • Repeat this step, taking a tiny stitch, drawing the needle through the loop, and pulling taut.

    • Ensure that the stitches are tight, and cut any excess threads.

    Instead of cutting the excess thread, I leave enough length at the end to “bury” the long threads inside the repair, where they will not show and are less likely to loosen up.

    Kathleen Slamka - Antwort

    We use a clear repair patch kind of tape to fix our tents called fixmytear repair tape. So much cheaper than paying a machinist to fix it. Apply it to both sides if you can for extra strength.

    https://www.amazon.com/Fixmytear-Magic-R...

    https://www.amazon.com/fixmytear-Magic-R...

    W731620 E - Antwort

Ziellinie

2 weitere Nutzer:innen haben diese Anleitung absolviert.

Brittany McCrigler

Mitglied seit: 03/05/12

88.898 Reputation

131 Anleitungen geschrieben

Team

iFixit Mitglied von iFixit

Staff

136 Mitglieder

16.573 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 18

Letzte 30 Tage: 81

Insgesamt: 9,749