Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Locate the two tabs with white arrows on them. They are located on either side of the brushroll cover.
-
Slide the tabs away from the center of the vacuum to unlock the brushroll cover.
-
Lift the brushroll cover upward.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the brushroll out by pulling the tab labeled "pull".
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Push down on the dust can lever to release the dust can in order to get to the filter grill.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the dust cup by lifting it off the dock.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Flip the device over so that the bottom is face up.
-
Remove the eight screws shown by rotating counter-clockwise with a T15 Torx screwdriver.
-
Two 14 mm Torx screws
-
Two 16 mm Torx screws
-
Four 21 mm Torx screws
-