Shark Rocket Zero-M Belt Replacement

Einleitung

This guide is intended to show how to access, remove, and replace the belt on a Shark Rocket Stick Vacuum with Self-Cleaning Brushroll. This replacement may be necessary if the brush roller is turning slowly or not at all.

Was du brauchst

Schritt 1 Belt

Shark Rocket Zero-M Belt Replacement, Belt: Schritt 1, Bild 1 von 1

Flip the vacuum on its right side.

Bearbeiten

Schritt 2

Shark Rocket Zero-M Belt Replacement: Schritt 2, Bild 3 von 3

Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

Bearbeiten

Schritt 3

Shark Rocket Zero-M Belt Replacement: Schritt 3, Bild 3 von 3

Turn the vacuum face down.
Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

Bearbeiten

Schritt 4

Shark Rocket Zero-M Belt Replacement: Schritt 4, Bild 3 von 3

Use a spudger to pry the side of the vacuum open.

Bearbeiten

Schritt 5

Shark Rocket Zero-M Belt Replacement: Schritt 5, Bild 3 von 3

Use a spudger to pry the old belt away from the two gears.
The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.

Bearbeiten