Einleitung

This guide will inform users on how to replace the hose inside the Steam Head attachment for the Shark Steam Pocket Mop.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Start by removing this quarter inch Phillips head screw
    • Start by removing this quarter inch Phillips head screw

    • Next remove the two 1/8th inch Phillips head screws at the bottom of the connector piece.

    • Next remove the nine 1/8th inch Phillips head screws along the base of the steam head connection.

    • Next remove the two 1/8th inch Phillips head screws along the base of the steam head connector.

    Kommentar hinzufügen

  2. Once all the screws are removed and the baseplate of the steam head connection has been placed aside, gently remove the connector from the bottom of the base.
    • Once all the screws are removed and the baseplate of the steam head connection has been placed aside, gently remove the connector from the bottom of the base.

    • Gently remove the end caps of the hinge piece of the connector piece with your fingers.

    • Gently remove the host connection from the back plate.

    Kommentar hinzufügen

    • Use your tweezers to remove the metal ring holding the hose to the plastic end piece and replace the hose / bit as needed.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jacob Howe

Mitglied seit 10.10.2017

501 Reputation

5 Anleitungen geschrieben

Team

USF Tampa, Team S13-G7, Cagle Fall 2017 Mitglied von USF Tampa, Team S13-G7, Cagle Fall 2017

USFT-CAGLE-F17S13G7

4 Mitglieder

5 Anleitungen geschrieben

Ok, but where do I get a replacement hose?

semajrolyat - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 3

Letzte 30 Tage: 25

Insgesamt: 278