Einleitung
This guide will inform users on how to replace the hose inside the Steam Head attachment for the Shark Steam Pocket Mop.
Was du brauchst
-
-
Start by removing this quarter inch Phillips head screw
-
Next remove the two 1/8th inch Phillips head screws at the bottom of the connector piece.
-
Next remove the nine 1/8th inch Phillips head screws along the base of the steam head connection.
-
Next remove the two 1/8th inch Phillips head screws along the base of the steam head connector.
-
-
-
-
Once all the screws are removed and the baseplate of the steam head connection has been placed aside, gently remove the connector from the bottom of the base.
-
Gently remove the end caps of the hinge piece of the connector piece with your fingers.
-
Gently remove the host connection from the back plate.
-
-
-
Use your tweezers to remove the metal ring holding the hose to the plastic end piece and replace the hose / bit as needed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
USF Tampa, Team S13-G7, Cagle Fall 2017 Mitglied von USF Tampa, Team S13-G7, Cagle Fall 2017
USFT-CAGLE-F17S13G7
4 Mitglieder
10 Anleitungen geschrieben
2 Kommentare
Ok, but where do I get a replacement hose?
Same question as semajrolyat: where to source replacement hose?
