Ersatzteile

Kein Ersatzteil erforderlich.

  1. Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.
    • Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.

    Kommentar hinzufügen

  2. While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.
    • While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Grip cordless drill firmly with left hand. Grip the cordless drill handle firmly with the right hand. Rotate the handle counterclockwise in order to remove the handle from the drill.

    Kommentar hinzufügen

    • The chuck sleeve is held on by a 20mm Phillips #2 screw in the center.This screw is reverse threaded. Insert a Phillips #2 screwdriver and rotate it clockwise to loosen and remove it.

    Kommentar hinzufügen

    • The threaded hole the screw was in is in the shape of a 6-point star. Insert a T40 Torx Key and rotate it clockwise to loosen and remove the chuck sleeve.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jameson

Mitglied seit 23.09.2014

228 Reputation

2 Anleitungen geschrieben

Team

USF Tampa, Team 2-3, Blackwell Fall 2014 Mitglied von USF Tampa, Team 2-3, Blackwell Fall 2014

USFT-BLACKWELL-F14S2G3

5 Mitglieder

7 Anleitungen geschrieben

For my drill, the Torx screw had to be rotated *counter-clockwise to remove. I'm not sure if that was an error in step #5 or some drills are different.

Thank you for the location of those screws btw.

"Step 5 — Remove the chuck sleeve

The threaded hole the screw was in is in the

shape of a 6-point star. Insert a T40 Torx Key

and rotate it *clockwise to loosen and remove

the chuck sleeve."

Joe Bailey - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 4

Insgesamt: 653