Zum Hauptinhalt wechseln

Repariere deine Sachen

Recht auf Reparatur

Werkzeug & Ersatzteile

Einleitung

Before opening the LCR-Reader, place a small bit of tape over the button on the top housing. This will keep the button from falling loose and being lost.

  1. Start by removing the 4 screws in the back of the device using a size 00 Philips screw driver. Start by removing the 4 screws in the back of the device using a size 00 Philips screw driver.
    • Start by removing the 4 screws in the back of the device using a size 00 Philips screw driver.

  2. Gently open the zif connector that holds the screen. Insert the replacement screen, and close the zif
    • Gently open the zif connector that holds the screen.

    • Insert the replacement screen, and close the zif

  3. When closing the housing, make sure the screen fits into the rectangle on the top.
    • When closing the housing, make sure the screen fits into the rectangle on the top.

    • If the screen is not in this rectangle, it may become damaged when the screws are tightened

    • Hold the screen in place from below; line up the button's edge of the top housing to line up with the bottom housing. Slide your finger out as you bring the top and bottom housings to meet.

    • Replace the 4 Philips screws in the back.

Ziellinie

Ein weiterer Nutzer hat diese Anleitung absolviert.

brittany

Mitglied seit: 16.07.2012

204 Reputation

5 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzten 24 Stunden: 1

Letzten 7 Tage: 2

Letzten 30 Tage: 2

Insgesamt: 280