Einleitung

This article will teach the user how to remove an old battery from a Sony Clie PEG-T615C with short and easy-to-follow steps.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Remove two screws from the thumb dial panel on the back of the device.
    • Remove two screws from the thumb dial panel on the back of the device.

  2. Remove one screw from the upper right corner on the back of the device.
    • Remove one screw from the upper right corner on the back of the device.

    • Remove one screw from the thumb dial panel on the right side of the device.

    • Remove one screw from lower right side of the device.

    • Remove one screw from the lower left side of the device.

    • Remove two screws from the bottom of the device.

    • Remove the thumb dial panel by sliding it away from the device.

    • You can do this step earlier, after you remove all of the screws from the thumb drive panel.

    • Remove the back panel, exposing the inside of the device.

    • Remove one screw located on the board below the battery.

    • Unplug the male battery plug on the battery wire from the female battery plug on the board.

    • Remove the battery by sliding it out of the side of the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Rob

Mitglied seit 04.10.2011

1 Reputation

2 Anleitungen geschrieben

Team

UW Stout, Team 5-6, Zhou Fall 2011 Mitglied von UW Stout, Team 5-6, Zhou Fall 2011

UWSTOUT-ZHOU-F11S5G6

4 Mitglieder

2 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 1

Letzte 7 Tage: 4

Letzte 30 Tage: 7

Insgesamt: 1,526