Was du brauchst
-
-
Begin by placing the camera upside down and removing the three small center screws.
-
-
-
Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.
-
Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.
-
-
-
Locate the camera's tripod mount located on the bottom of the camera.
-
Carefully remove the camera's tripod mount and place it aside.
-
Be careful not to lose this piece.
-
Rotate the silver panel labeled 4x clockwise.
-
-
-
-
Align the camera so that the side with "4x Optical Zoom" is facing toward you.
-
Gently twist the bottom corner clockwise until you feel the side panel unlock.
-
Lift off the side panel and set aside.
-
-
-
Rotate the camera 180 degrees to face the side panel with the lanyard loop on it.
-
Gently lift the panel vertically until it lifts off
-
-
-
Position the camera so the bottom is facing up and the display away from the surface.
-
Gently pry the screen portion from the camera portion with your fingers or a plastic prybar.
-
Lay the display flat to expose the circuit board and the display control ribbon cables.
-
-
-
Using a flat head screw driver gently pry up on the tab securing the larger ribbon cable which connects the display screen and camera sensor / battery housing.
-
Remove the ribbon cable connecting the LCD display and camera sensor / battery housing.
-
Following the same procedure, uninstall the ribbon cable connecting the main camera controls to the camera sensor and battery housing
-
-
-
Now turn your attention to the camera sensor and battery housing. Identify the two connection points of the large ribbon cable.
-
Carefully place a flathead screwdriver under the left ribbon cable connection point and pull up to disconnect.
-
Repeat the previous step but this time carefully remove the right ribbon cable connection point.
-
After both sides of the ribbon cable have been disconnected it is ready to be replaced.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Clemson, Team 2-3, Benson Spring 2012 Mitglied von Clemson, Team 2-3, Benson Spring 2012
CLEM-BENSON-S12S2G3
3 Mitglieder
11 Anleitungen geschrieben
Ein Kommentar
The locking meachanism on the Monitors ribbon cable is broken on my camera.
It pivots and locks the ribbon down to create a secure connection. However, because of the Brocken lock one side is not locked down therefore the Monitor turns off when tapped.
Is there a place that I could get a replacement for this lock?
much appreciated.
