Was du brauchst
-
-
Using the screwdriver, remove all screws (black 2.5mm) from outermost layer of the assembly.
-
-
-
Also using the screwdriver, remove screws (black 1mm) underneath articulated LCD screen.
-
Remove the marked 2.5 mm screws with the screwdriver
-
-
-
Using the same plastic opening tools, separate the screen and back assembly from the front portion of the camera
-
Once the back assembly is slightly detached, pull the media covers for the HDMI and Multimedia ports
-
-
-
-
Move side panel to get access to screws
-
Remove two screws (black 2.5mm) with PH #0 screwdriver
-
-
-
Carefully unplug ribbon connector to fully detach LCD screen assembly from camera
-
-
-
Remove remaining screw which holds the copper casing in the camera
-
-
-
Using the plastic opening tools, carefully pry off the copper casing at the two pictured points.
-
Remove casing
-
-
-
Place your finger into the battery port and push up on the SD card holder to push it out of its socket.
-
-
-
Carefully remove the gold ribbons from the ports of the motherboard by lifting the gray tabs and pulling away the ribbon
-
You may want to use tweezers to remove the gold ribbons as a more delicate and safe approach, but this is not required
-
-
-
Remove the SD card holder. It should easily come out because all of the prerequisite screws were already removed.
-
-
-
Carefully remove the last gold ribbon by lifting the gray tab and sliding out the ribbon.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team 21-1, Maness Winter 2017 Mitglied von Cal Poly, Team 21-1, Maness Winter 2017
CPSU-MANESS-W17S21G1
5 Mitglieder
10 Anleitungen geschrieben
