Sony DVP-SR200P Power Supply Circuit Board Replacement

Einleitung

The following instruction is designed to help you replace the Sony DVP-SR200P power supply circuit board and power cord. Extreme caution must be used while handling the motherboard and other fragile internal components to prevent damage. Furthermore, there's a chance of electric shock, so you need to be extra cautious. You may confidently do this installation with moderate difficulty if you carefully follow our comprehensive instructions.

In order to ensure that the power supply circuit board and power cable replacement goes smoothly and successfully, this guide attempts to give you a clear and concise set of instructions. Throughout the procedure, be mindful of the exposed motherboard's fragility and handle it with extreme caution. Let's get started on revitalizing your Sony DVP-SR200P with a new power supply system, following our step-by-step instructions for a hassle-free experience.

Was du brauchst

Schritt 1 Top Cover

Sony DVP-SR200P Power Supply Circuit Board Replacement, Top Cover: Schritt 1, Bild 1 von 2

Sony DVP-SR200P Power Supply Circuit Board Replacement, Top Cover: Schritt 1, Bild 2 von 2

Remove the five #1 Phillips screws (black, 3/16") attaching the cover to the DVD player.
One 3/16" screw on the right side of the DVD player.
One 3/16" screw on the left side of the DVD player (directly opposite of other screw).
Three 3/16" screws on the back of the DVD player.

Bearbeiten

Schritt 2

Slide the cover away from the front of the DVD player until it is off.

Bearbeiten

Schritt 3 Processing Board

Sony DVP-SR200P Power Supply Circuit Board Replacement, Processing Board: Schritt 3, Bild 1 von 1

Remove the blue tape from the processing board by gently pulling upward.

Bearbeiten

Schritt 4

Use the tweezers to remove the four sets of wires connected to the processing board. Start with the cord located in front of the row of three cords.
The wires may be difficult to remove. Wiggling them while lifting them up may help remove them.

Bearbeiten

Schritt 5

Handle the processing board with care. It is fragile.
Unscrew the two #1 Phillips screws (silver, 3/16") located on the two edge corners of the processing board.

Bearbeiten

Schritt 6

Orient the DVD player so that you are facing the video and audio jacks.
Unscrew the two #1 Phillips screws (silver, 3/16") located on the outside of the DVD player
The processing board is now free to be removed and replaced.

Bearbeiten

Schritt 7 Power Supply Circuit Board

Sony DVP-SR200P Power Supply Circuit Board Replacement, Power Supply Circuit Board: Schritt 7, Bild 1 von 1

Caution: The circuit board contains capacitors (they look like cylinders) that can shock you if they discharge. Be careful not to touch them as you work. If possible, use a capacitor discharge probe to safely rid the capacitors of dangerous charges.
Unhook the power supply connector from the power supply board by pressing down on the small latch.

Bearbeiten

Schritt 8

Orient the DVD player so the back of the DVD player is opposite of you.
Unscrew the two silver 4.8 mm Phillips #1 screws that attach the power supply circuit board to the bottom of the DVD player.

Bearbeiten