Einleitung

The replacement of the rear casing requires removal of multiple screws around the entire camera and inside the battery pack. Once the fasteners are removed, you can carefully pry off the rear case.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Open the battery pack door by moving the slider to "OPEN".
    • Open the battery pack door by moving the slider to "OPEN".

    • Remove the 3.25 mm silver screw inside the battery pack with a Phillips screwdriver.

    Kommentar hinzufügen

  2. Remove the 3.25 mm exterior screw with a Phillips screwdriver.
    • Remove the 3.25 mm exterior screw with a Phillips screwdriver.

    Kommentar hinzufügen

    • Use the spudger to raise the corner of the case from the camera.

    • One component of the front case should now be separate from the camera.

    Kommentar hinzufügen

    • Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.

    Kommentar hinzufügen

    • Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.

    Kommentar hinzufügen

    • Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.

    Kommentar hinzufügen

    • Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.

    Kommentar hinzufügen

    • Using the spudger again, carefully pry from the top of the camera to remove the back frame.

    • The back frame is fragile, so use the spudger gently.

    Pull the back pannel up starting at the bottom of the frame. There is a little hinge at inside the frame the top that will move up and make it much easier to remove the back panel (almost without effort)

    meertdavid - Antwort

    • The back case should now be removed and look like this.

    Does this part contain battery stopper?

    Gennady - Antwort

    I guess not. battery stopper is on the body.

    Chau Jieying -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Emily Trujillo

Mitglied seit 08.04.2014

1.081 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team 8-9, Regan Spring 2014 Mitglied von Cal Poly, Team 8-9, Regan Spring 2014

CPSU-REGAN-S14S8G9

4 Mitglieder

7 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 10

Insgesamt: 1,490