Sony NEX-5R Rear Case Replacement

Einleitung

The replacement of the rear casing requires removal of multiple screws around the entire camera and inside the battery pack. Once the fasteners are removed, you can carefully pry off the rear case.

Was du brauchst

Schritt 1 Front Case

Sony NEX-5R Rear Case Replacement, Front Case: Schritt 1, Bild 1 von 2

Sony NEX-5R Rear Case Replacement, Front Case: Schritt 1, Bild 2 von 2

Open the battery pack door by moving the slider to "OPEN".
Remove the 3.25 mm silver screw inside the battery pack with a Phillips screwdriver.

Übersetzen

Schritt 2

Remove the 3.25 mm exterior screw with a Phillips screwdriver.

Übersetzen

Schritt 3

Use the spudger to raise the corner of the case from the camera.
One component of the front case should now be separate from the camera.

Übersetzen

Schritt 4 Rear Case

Sony NEX-5R Rear Case Replacement, Rear Case: Schritt 4, Bild 1 von 1

Remove the three (3.5 mm) screws from the bottom of the camera with the Phillips screwdriver.

Übersetzen

Schritt 5

Open the HDMI port, and remove the the two (3.5 mm) Phillips screws exposed on that side.

Übersetzen

Schritt 6

Remove the two 4mm screws from the interior of the battery pack, and one 3.5mm screw from beside it.

Übersetzen

We already removed the screw next to battery lock. The one close to blue plastic lock.

Harbert Wolfstein - 30. Mär 2019 Antwort

How to repair this part of the interior pack if my blue thing is broken

@AntoineTy - 14. Okt 2023 Antwort

Schritt 7

Looking at the bottom of the camera, use the spudger to lift the rear case away from the camera body.

Übersetzen

Schritt 8

Using the spudger again, carefully pry from the top of the camera to remove the back frame.
The back frame is fragile, so use the spudger gently.

Übersetzen

Pull the back pannel up starting at the bottom of the frame. There is a little hinge at inside the frame the top that will move up and make it much easier to remove the back panel (almost without effort)

meertdavid - 19. Aug 2018 Antwort

The most difficult part of this disassembly is this plastic part. Very thin, flimsy and tend to easily break. Pay extra attention when prying this frame, especially the top part, between the screen hinges.

Harbert Wolfstein - 30. Mär 2019 Antwort

Update to my previous comment:

Remove the top case part where the shutter button, play button etc so that flimsy plastic frame can come out easily.

Harbert Wolfstein - 29. Apr 2019 Antwort