Einleitung

How to replace the thermal paste into your laptop.

Ersatzteile

Kein Ersatzteil erforderlich.

Turn the laptop upside down
  • Turn the laptop upside down

  • The battery is located on the front right side of the laptop; the opposite side from the floppy disk drive.

Kommentar hinzufügen

As shown by the arrow, slide the plastic cover up and then pull out and downwards.
  • As shown by the arrow, slide the plastic cover up and then pull out and downwards.

  • You should now be able to pull the battery out.

Kommentar hinzufügen

  • Remove the four 16mm Phillips screws bordering the edge of the laptop, indicated here.

Kommentar hinzufügen

  • Remove the 4mm Phillips screw on the right rear side of the laptop next to the audio ports.

  • This will release the speaker grille.

Kommentar hinzufügen

  • Flip the computer back over and open the screen.

Kommentar hinzufügen

  • Slide the blue speaker grille (located above the keyboard) to the right and gently pull upward. The grille will still be connected by a white electrical strip.

  • Carefully pull out the white electrical strip.

Kommentar hinzufügen

  • Remove the 4mm Phillips screw in the center (located to the left of the green strip).

  • Carefully pull the green strip straight up to disconnect it.

  • The keyboard can now be removed.

Kommentar hinzufügen

  • Remove the two 4mm Phillips screws in the center of the computer located on each side of the copper electrical strip.

Kommentar hinzufügen

  • Remove the four 4mm Phillips screws around the hard drive cage.

  • WARNING: DVD drive is now loose as well.

  • Lift hard drive cage straight up.

  • Carefully disconnect the copper strip to pull out the hard drive.

Kommentar hinzufügen

  • With the hard drive removed, unscrew the four 6mm brass colored, Phillips screws under the hard drive cage

  • This will allow you to remove the hard drive mounting bracket

Kommentar hinzufügen

  • Remove the three 6mm brass colored, Phillips screws that hold the fan cage in place.

Kommentar hinzufügen

  • Remove the two 4mm black Phillips screws shown here.

  • Remove the 18mm silver Phillips screw shown here.

  • Now remove the silver tab.

Kommentar hinzufügen

  • Remove the blue and red fan power cords.

Kommentar hinzufügen

  • Carefully pull up and out on the metal heat sink and fan bracket.

  • You should be able to see the thermal paste.

Kommentar hinzufügen

  • To remove thermal paste thoroughly, put isopropyl alcohol (70% or greater) on a paper towel and wipe thermal paste off. Some force may be required.

  • Apply new thermal paste to CPU.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Sara Lillard

Mitglied seit 11.04.2011

117 Reputation

8 Anleitungen geschrieben

Team

Cal Poly, Team 12-36, Maness Spring 2011 Mitglied von Cal Poly, Team 12-36, Maness Spring 2011

CPSU-MANESS-S11S12G36

4 Mitglieder

8 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 5

Insgesamt: 3,285