Repariere deine Sachen Community Store

Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement

Einleitung

The keyboard should be replaced if it is missing keys or non-functional.

Was du brauchst

  1. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Battery: Schritt 1, Bild 1 von 1

    • Power off the laptop.

    • Unplug the charging cable and any other cables plugged into the laptop.

    • Failure to remove or unplug any cables could result in electric shock.

    • Turn the laptop over so that the back panel is facing upwards.

    Bearbeiten

  2. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 2, Bild 1 von 1

    • Locate two switches above the battery that lock it into place.

    • Push the left-hand switch, that says "lock" above it, so that it is unlocked.

    Bearbeiten

  3. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 3, Bild 1 von 1

    • Push and hold the right-hand switch, which says "release" above it, and lift the battery up out of its place.

    Bearbeiten

  4. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Optical Drive: Schritt 4, Bild 1 von 1

    • Locate and unscrew the two highlighted 8 mm Phillips #1 screws.

    • There will be three dots next to the desired screws

    Bearbeiten

  6. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 5, Bild 1 von 1

    • Grip the cover of the optical drive and slide it out.

    • If it does not come out, do not force it. Double check to make sure the screws are entirely removed.

    Bearbeiten

  7. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Back Panel: Schritt 6, Bild 1 von 3 Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Back Panel: Schritt 6, Bild 2 von 3 Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Back Panel: Schritt 6, Bild 3 von 3

    • Remove all the 8mm Phillips #1 screws on the backside of the laptop.

    • There are three 3mm and two 5.3mm screws under the battery that also need to be taken out.

    • There are three 3mm screws under the optical drives that also need to be taken out.

    • Remove the RAM panel in addition to the other screws. For further instructions, refer to the RAM replacement guide.

    Bearbeiten

  8. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 7, Bild 1 von 3 Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 7, Bild 2 von 3 Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 7, Bild 3 von 3

    • Pry along the edges of the back panel using the spudger.

    • If you are struggling to remove the back panel with a moderate amount of force, do NOT apply any additional force, instead double check to make sure all the screws were removed before attempting again.

    Bearbeiten

  9. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Fan: Schritt 8, Bild 1 von 1

    • Locate and remove three 5.3 mm Phillips #1 screws on the bottom of the fan.

    • Locate and remove the four 5.3 mm Phillips #1 screws on the top of the fan.

    Bearbeiten

  10. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 9, Bild 1 von 1

    • Locate and remove the four 3mm Phillips #1 screws above the processor and attached to the bronze heat-pipes.

    • Gently lift up the fan and heatsink from the the laptop.

    • If the fan and heatsink will not lift up with ease, do NOT apply any additional force. Check again to see if all necessary screws are removed.

    Bearbeiten

  11. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 10, Bild 1 von 1

    • The fan attached onto the heat sink with electrical tape. Removing the electrical tape allows you to replace the fan.

    Bearbeiten

  12. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement, Keyboard: Schritt 11, Bild 1 von 1

    • Locate the two highlighted circular openings and push the keyboard out.

    • There is a ribbon cable attaching the keyboard to the back of the motherboard. Avoid damaging the ribbon when pushing out the keyboard.

    Bearbeiten

  13. Sony Vaio VGN-NW240F (PCG-7184L) Keyboard Replacement: Schritt 12, Bild 1 von 1

    • Detach the ribbon cable to separate the keyboard from the laptop.

    • Push open the brown clamp at the base of the ribbon to release it.

    Bearbeiten
Abschluss

To reassemble your device, follow these instructions in reverse order.

6 weitere Nutzer:innen haben diese Anleitung absolviert.

Autor:in

mit 4 anderen Mitwirkenden

Kevin McGowan

Mitglied seit: 04/22/14

619 Reputation

4 Anleitungen geschrieben

Auszeichnungen: 13

+ 10 weitere Auszeichnungen

Team

Cal Poly, Team 9-17, Regan Spring 2014 Mitglied von Cal Poly, Team 9-17, Regan Spring 2014

CPSU-REGAN-S14S9G17

4 Mitglieder

18 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 5

Insgesamt: 7,001