Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Turn off the device
-
Remove the SIM and the memory cards.
-
Remove 4x rubber corners.
-
There are 6x black screws Torx T4, remove them.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a plastic tool and separate the rear bezel.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect the touch screen flex cable.
-
Disconnect the battery flex cable.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
With a hair dryer or heat gun warm the glass, at first for about 2-3 minutes.
-
Use a thin plastic tool, like a plastic pick and start the separation from the underside.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Plastic Cards$2.99-
Now continue with a plastic card.
-
Remove the touch screen.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Now is time to test the phone.
-
With a plastic pick gently scrape the glue.
-
With a cloth and isopropyl alcohol clean the LCD.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
On the new touch screen or on the main frame put adhesive sticker 3mm.
-
Lift the logic board a little bit, so that the touch screen flex cable can pass.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Reassemble the device.
-
That's all.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
6 weitere Nutzer:innen haben diese Anleitung absolviert.