Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the back cover and any installed SIM and memory cards.
-
There are 8x black screws Torx T4. Remove them.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the small black rubber at the lower left corner.
-
Under it is the battery flex cable, disconnect it.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a plastic tool to separate the middle frame.
-
The battery is glued to the middle frame with an adhesive tape.
-
Loudspeaker
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect the touch screen flex cable.
-
Under it is the LCD flex cable. Disconnect it also.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Cover the glass with a scotch tape.
-
Warm the glass for about minute.
-
With a cutter lift a little the glase to make a room for the plastic tool.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
In diesem Schritt verwendetes Werkzeug:Plastic Cards$2.99-
Carefully put the plastic tool between the glass and the LCD.
-
Remove the display frame.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Install adhesive tape.
-
Start with the reassembling.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
12 weitere Nutzer:innen haben diese Anleitung absolviert.
4 Kommentare
Grazie! È stato davvero utilissimo. :)
Doesn't the original glass and digitalizer come out with its biadesive?