Einleitung
Diese Anleitung zeigt dir, wie du den Akku austauschen kannst.
Was du brauchst
-
-
Erwärme die Rückabdeckung um die Verklebung aufzuweichen.
-
Setze einen Saugnapf auf und ziehe daran. Setze einen Metallspatel in den entstandenen Spalt.
-
-
-
-
Setze in den Spalt ein paar Plektren ein und lasse diese um den Rand herum laufen. Dadurch wird die Klebeverbindung aufgetrennt.
-
Entferne die Rückabdeckung.
Does the adhesive in this step need to be replaced? Don't really want to lose the water proofing…
Usually the adhesive is slightly damaged during the opening procedure which might void the water resistance of the phone. So to re-seal the back cover it’s best to use fresh adhesive. If you don’t find a pre-cut adhesive tailored to the Z5 you can go with double-sided adhesive tape or an adhesive glue. If you find the remaining adhesive in good condition and trust it to do its job, the re-use it by heating it up a little bit and applying pressure to the re-attached back cover for a few hours.
-
-
-
Löse den Akkustecker und ziehe die Klebestreifen heraus.
-
Hebele den Akku hoch.
Can you tell me the wire connection colour code of battery? because i brought the ones but its not working.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
25 weitere Nutzer:innen haben diese Anleitung absolviert.
Besonderer Dank geht an diese Übersetzer:innen:
100%
VauWeh hilft uns, die Welt in Ordnung zu bringen! Wie kann ich mithelfen?
Hier starten ›
7 Kommentare
worked a treat - simple straightforward - thanks!!
umm how do you put the cover back on?
Just push and then consolidate with heat, I used hair dryer.
can reuse the same cover, or need a new unit ?